HW-01 · Sink, tap and waste
Sink cabinet
800 mm body with the sink opening cut at the factory, the waste route through the base, and clear space under the bowl for the trap. Everything else in a run can be planned on paper; this one needs the drain position settled first.
- Width
- 800
- Depth
- 656
- Height
- 900
Prices are quoted per order — module mix, finish, counter and freight all move. A quote is valid 15 days.
Catalogue & dimensions
PDF with the full module range and the appliance cut-out library.
Specification
HW-01 in numbers
Millimetres, as supplied. Every module shares 900 mm height and the 2.5 inch castor line, so any two line up without packing.
| Body width | 800 mm |
|---|---|
| Body depth | 656 mm |
| Body height | 900 mm |
| Fits | Sink, tap, trap and waste outlet |
| Castors | 2.5 inch, standard |
| Panel build | 0.45 mm 304 stainless both faces over aluminium honeycomb core |
| Panel thickness | 18 mm cabinet body, 20 mm door and end panel |
| Colour range | Standard colour card, or matched to sample at an extra charge |
Figures are the finished cabinet dimensions from the standard range. Where a module departs from the common 656 mm depth it is stated on the module page, not averaged.
What it does
The only module that needs plumbing
800 mm body with the sink opening cut at the factory, the waste route through the base, and clear space under the bowl for the trap. Everything else in a run can be planned on paper; this one needs the drain position settled first.
In the standard configuration
- Door panel, left and right side panels, base panel, back panel
- Stainless steel shelf and a false door
- C-shaped handle-free alloy profile
- 304 stainless countertop with the sink aperture cut
- Sink and tap included in the standard configuration
- Skirting board and 2.5 inch castors
Working end
Nearest the house door — that is the end that gets walked to carrying something wet.
Against a wall
The waste leaves through the base or the back panel, so the wall side stays usable.
Beside prep
The 800 mm body gives a bowl plus a landing strip either side.
Straight answers
Questions about this module
Does the sink cabinet need the drain position decided first?
Yes. Waste does not run uphill, so the drain, soakaway or tank has to be within reach before the run is positioned. It is the one module where a site decision comes before the cabinet decision.
Is the sink included?
Yes in the standard configuration — sink, tap and the trap space are part of the module. If you want to supply your own bowl, send the cut-out and we cut to it instead.
Can the sink go at the far end of a run?
It can, but check the waste route first. Most runs put the sink at the end nearest the house because that is where the drain usually is.
Adjacent modules
What usually sits next to it
Because every module shares the same height and depth, any of these lines up without adjustment.
Page last updated · Reviewed by the BOGEQI technical team, Foshan Bogeqi Cabinetry Co., Ltd.